Pièces

Aucune pièce nécessaire.

Remove protective flap by pulling directly out from the top.
  • Remove protective flap by pulling directly out from the top.

  • The two clips will pop out

Ajouter un commentaire

Remove Faceplate. There is a tab where the finger is located in the picture that needs to be pulled up.
  • Remove Faceplate. There is a tab where the finger is located in the picture that needs to be pulled up.

  • The Faceplate will then easily lift off.

Ajouter un commentaire

  • Using a a T5 Torx bit screwdriver, remove the four screws located on the back of the device turning counter clockwise.

  • The link to purchase this screwdriver is Located here.

Ajouter un commentaire

  • This is what the device looks like once you have taken the screws out and opened the device.

Ajouter un commentaire

  • The Motherboard and screen will pop out of the back case easily.

    • Be careful when doing this step, the components are fragile.

Ajouter un commentaire

  • To remove the screen from the motherboard there are going to be three tabs that need to pulled up.

  • ** This step needs to be done with special care because it is very fragile.**

  • Once they are all three popped up the motherboard and screen will separate easily.

Ajouter un commentaire

  • Click here for Palm m105 screen replacement

  • Now that the screen and motherboard are separated you may discard the broken screen. The best way to dispose of the broken screen is to: Recycle it

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Erik Thompson

Membre depuis le 04/10/2011

31 Réputation

5 tutoriels rédigés

Équipe

UW Stout, Team 1-3, Zhou Fall 2011 Membre de l'équipe UW Stout, Team 1-3, Zhou Fall 2011

UWSTOUT-ZHOU-F11S1G3

4 membres

7 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 1

30 derniers jours : 4

Total : 428