Pièces

Aucune pièce nécessaire.

  1. Eject the disk tray from the DVD player before removing power supply.
    • Eject the disk tray from the DVD player before removing power supply.

    Ajouter un commentaire

  2. Evenly lift upward on the disk tray front cover (not slanted, as pictured). This will allow for easier dissasembly of the player.
    • Evenly lift upward on the disk tray front cover (not slanted, as pictured). This will allow for easier dissasembly of the player.

    Ajouter un commentaire

    • Remove 3 screws running along back edge of case cover.

    • Remove 2 screws from each side of case cover.

    Ajouter un commentaire

  3. Livraison gratuite pour les commandes de plus de 20 $
    Indiquez le code BLUEANDBLACK au moment de payer
    Livraison gratuite pour les commandes de plus de 20 $
    Indiquez le code BLUEANDBLACK
    • Grab edges of cover, pull outward slightly, and pull straight up.

    Ajouter un commentaire

    • Lift up the 5 tabs securing the front panel to the chassis. There are 3 on the bottom, and 2 on the inside edges of the panel. Panel should then lift off the player.

    Be careful not to disturb the electrical connectors on the circuit board.

    philcarpenter439 - Réponse

    • Locate the 4 screws securing the disk drive assembly. There are two on each side.

    • Use a narrow screwdriver to remove all 4 screws.

    • Remove the blue ribbon wire from its connector. When doing this, be cautious to not damage the connector.

    Using a magnetic tip screwdriver will make it a lot

    philcarpenter439 - Réponse

    • Lift assembly by the front to pull metal bracket from the power board.

    • Pull up back end and lift drive out.

    Ajouter un commentaire

    • With the drive assembly separate from the player, hold as shown and pull the bracket edges away from the disk drive.

    • Lift bracket off and reserve for re-assembly.

    Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

2 autre(s) ont terminé cette réparation.

William

Membre depuis le 26/04/2011

250 Réputation

2 tutoriels rédigés

Équipe

Cal Poly, Team 18-20, Garner Spring 2011 Membre de l'équipe Cal Poly, Team 18-20, Garner Spring 2011

CPSU-GARNER-S11S18G20

4 membres

11 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 4

30 derniers jours : 15

Total : 4,467