Introduction

This guide will show you how to remove the motherboard so you can replace it.

Pièces

Aucune pièce nécessaire.

Move the switch on the battery door to the Open position.
  • Move the switch on the battery door to the Open position.

  • The door will automatically swing open after you let it go.

Ajouter un commentaire

Push the small gray tab on the top right corner to the left. The battery will pop out slightly.
  • Push the small gray tab on the top right corner to the left. The battery will pop out slightly.

  • Keep your finger clear of the battery when it pops out.

Ajouter un commentaire

  • Push the memory card in and let go.

  • The memory card will pop out slightly.

  • Pull out the memory card.

Ajouter un commentaire

  • Unscrew the small screws on the sides of the camera.

  • The screws on the left side(#00P, 4.7mm) are longer than the screw on the right side(#00P, 3.3mm).

Ajouter un commentaire

  • Unscrew the three small screws on the bottom(#00P, 3.3mm).

  • The bottom will fall off.

Ajouter un commentaire

  • Lift up the bottom back cover by prying the bottom edge with the spudger.

  • Gently lift up the back cover with your hand from the bottom to the top.

Ajouter un commentaire

  • Lift the tabs on the ZIF connectors.

  • The ribbon cables should easily come out of the ZIF connectors.

Ajouter un commentaire

  • Using the spudger, pry off the top cover by gliding the spudger along the entire edge between the top cover and the front cover.

  • Be careful not to damage the cylindrical capacitor on the circuit board under the top cover.

Ajouter un commentaire

  • Remove the small screw in the hole towards the top of the camera(#00P, 5.4mm).

Ajouter un commentaire

  • Use the spudger to lift up the back logic board.

  • Using your fingers, gently wiggle and pull off the back motherboard.

  • You will hear a click when you lift it up.

Ajouter un commentaire

  • Remove the small screw holding down the lower motherboard(#00P, 3.2mm).

Ajouter un commentaire

  • Use the spudger to lift the upper tab from the main housing.

  • Gently lift the lower tab from the main body by prying it with your finger.

  • Gently pull off the plastic motherboard housing sideways.

Ajouter un commentaire

  • Gently lift the tabs on the ZIF connectors connecting the lens to the front motherboard.

  • Once you lift the tabs the ribbons should fall right out and the front motherboard should be free.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Karissa

Membre depuis le 13/04/2012

50 Réputation

8 tutoriels rédigés

Équipe

Cal Poly, Team 6-23, Amido Spring 2012 Membre de l'équipe Cal Poly, Team 6-23, Amido Spring 2012

CPSU-AMIDO-S12S6G23

4 membres

10 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 1

30 derniers jours : 5

Total : 1,021