Introduction

In order to repair the problems that may arise while using the Panasonic PV-GS9 you must disassemble the camcorder entirely. This will allow you to have three large pieces of the camcorder from which all the repairs can be made.

Pièces

Aucune pièce nécessaire.

Using a plastic opening tool, remove the record/playback and record/power control knobs from the camcorder.
  • Using a plastic opening tool, remove the record/playback and record/power control knobs from the camcorder.

Ajouter un commentaire

Open the tape compartment.
  • Open the tape compartment.

  • Using a #00 Phillips head screwdriver, remove the two 4.5mm screws from the camcorder.

Ajouter un commentaire

  • Use a plastic opening tool to remove the gray trim piece from top of the camcorder.

  • Take care when removing the trim piece. The plastic parts are fragile and can break easily.

Ajouter un commentaire

  • Rotate the camcorder so that the eye piece is facing you, and remove the battery. Remove the four black 4.5mm screws, which sit behind the battery. Then, remove the 5th screw to the right of the battery dock.

  • Be careful not to lose any screws whilst trying to remove them.

Ajouter un commentaire

  • Rotate the camcorder so that the tape compartment is facing you. Remove the single 4.5mm black screw, which is above the hook for the hand strap.

  • It may help you during this step to undo the strap on one end.

  • Next, rotate the camcorder so that the lens is facing you. Remove the single 4.5mm black screw from the front panel.

Ajouter un commentaire

  • Rotate the camcorder so that the bottom is facing towards you. Remove the single remaining 4.5mm black screw from the bottom.

  • Next, while still having the bottom of the camcorder facing you, remove the four silver 4.5mm screws from the body.

Ajouter un commentaire

  • Open the LCD screen on the side of the camcorder.

  • Using a #00 screwdriver, remove the two 4.5mm silver screws located on either side of the hinge of the LCD screen.

Ajouter un commentaire

  • Very carefully remove the front cover from the main body of the camcorder.

  • This should come apart with relative ease, however a plastic opening tool may help you remove this panel a little more easily.

  • There is a ribbon cable attached to the front panel and the camcorder body, so be careful not to pull that off when you remove this panel.

Ajouter un commentaire

  • Using your fingers, carefully pull the ribbon cable away from the logic board.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Une autre personne a terminé cette réparation.

Trevor Johnson

Membre depuis le 18/04/2010

31 Réputation

2 tutoriels rédigés

Équipe

Cal Poly, Team 7-9, Maness Spring 2010 Membre de l'équipe Cal Poly, Team 7-9, Maness Spring 2010

CPSU-MANESS-S10S7G9

4 membres

8 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 1

30 derniers jours : 2

Total : 2,238