Aller au contenu principal

Cette version peut contenir des modifications incorrectes. Passez au dernier aperçu vérifié.

Ce dont vous avez besoin

  1. Cette étape n’est pas traduite. Aidez à la traduire

    : étape 1, image 1 de 3 : étape 1, image 2 de 3 : étape 1, image 3 de 3
    • With the front display of the device facing you, rotate the device 90 degrees counter clockwise.

    • Now rotate the device 180 degrees and remove the second screw.

    • Remove the screw that is on the right side of the panel facing you.

    • Remove all screws with a phillips head screwdriver.

  2. Cette étape n’est pas traduite. Aidez à la traduire

    : étape 2, image 1 de 2 : étape 2, image 2 de 2
    • Rotate the device so that the back faces you.

    • Using a phillips head screw driver, locate and remove the two screws highlighted by the red circles in image one.

  3. Cette étape n’est pas traduite. Aidez à la traduire

    : étape 3, image 1 de 1
    • Before removing cover make sure that the back of the device is facing you.

    • Remove the top cover by bending out on the sides, and pulling the cover towards you while applying upward pressure.

  4. Cette étape n’est pas traduite. Aidez à la traduire

    : étape 4, image 1 de 3 : étape 4, image 2 de 3 : étape 4, image 3 de 3
    • Pull up the two tabs on top

    • Pull the the three tabs on the side. One is on the left, and two are on the right side of the device when it is facing you.

    • Depress the four tabs on the bottom of the device with a flat head screwdriver.

  5. Cette étape n’est pas traduite. Aidez à la traduire

    : étape 5, image 1 de 1
    • Carefully pull off the front panel of the device.

    • The front is attached to the device with cables so be careful when removing.

  6. Cette étape n’est pas traduite. Aidez à la traduire

    : étape 6, image 1 de 2 : étape 6, image 2 de 2
    • Remove the four screws around the DVD drive with a phillips head screwdriver.

  7. Cette étape n’est pas traduite. Aidez à la traduire

    : étape 7, image 1 de 1
    • The DVD player is attached to the power supply.

    • Remove the wire attaching it by firmly pulling on the wire until it releases.

  8. Cette étape n’est pas traduite. Aidez à la traduire

    : étape 8, image 1 de 1
    • Flip the DVD drive so that the bottom is facing you.

    • Pull on the blue ribbon cable until it releases.

    • To place the new DVD drive in just follow these steps in reverse.

Ligne d'arrivée

2 autres ont terminé cette réparation.

Nathan Cheadle

Membre depuis le 04/15/10

161 Réputation

7 tutoriels rédigés

Équipe

Cal Poly, Team 16-5, Maness Spring 2010 Membre de l'équipe Cal Poly, Team 16-5, Maness Spring 2010

CPSU-MANESS-S10S16G5

4 membres

7 tutoriels rédigés

0 commentaires

Ajouter un commentaire

Nombre de vues :

Dernières 24 heures : 1

7 derniers jours : 2

30 derniers jours : 9

Total : 1,398