Cette version peut contenir des modifications incorrectes. Passez au dernier aperçu vérifié.
Ce dont vous avez besoin
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Disconnect the battery by pulling the two red wires apart.
-
Remove the battery by releasing the battery retaining straps.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Remove the small retaining clip using a plastic opening tool.
-
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
The propeller, gear, and rod can be removed by simply lifting them off the motor.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Disconnect the connector at the bottom of the motor assembly.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Remove the three 5mm screws on the top of the motor assembly with a PH00 bit.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Remove the three 5mm screws on the bottom again using a PH00 bit.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Carefully wiggle out the motor assembly out of the arm.
-
Annulation : je n'ai pas terminé ce tutoriel.
5 autres ont terminé cette réparation.
2 commentaires
I need to know this also. replaced cross.member but did not put motors in original spots now my drone goes crazy and erratic