Introduction

Water damage or a faulty electrical opponent may make the Pioneer Elite Pro-R06U shut off intermittently or fail to power on. Removing the faulty board and installing a new one should get the receiver back up and running.

Pièces

Aucune pièce nécessaire.

Remove the two 6.4 mm Phillips screws on each side of the device's casing.
  • Remove the two 6.4 mm Phillips screws on each side of the device's casing.

Ajouter un commentaire

Remove the three 6.5 mm Phillips screws on the back of the device casing.
  • Remove the three 6.5 mm Phillips screws on the back of the device casing.

Ajouter un commentaire

Grip the front panel in one hand and the back of the casing in the other. Pull the casing back, and slide it up and away from the inner box.
  • Grip the front panel in one hand and the back of the casing in the other. Pull the casing back, and slide it up and away from the inner box.

Ajouter un commentaire

Gently pull upward and unplug cables D4 and D5.
  • Gently pull upward and unplug cables D4 and D5.

Ajouter un commentaire

Remove the two 7/16 inch Phillips screws to the left and right of the power supply port.
  • Remove the two 7/16 inch Phillips screws to the left and right of the power supply port.

  • Remove three 5/16 inch Phillips screws from the corners of the board.

Ajouter un commentaire

Remove the power supply board by pulling it toward the interior of the device then lifting.
  • Remove the power supply board by pulling it toward the interior of the device then lifting.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Cody Carter

Membre depuis le 30/01/2018

1 049 Réputation

6 tutoriels rédigés

Équipe

Baylor, Team S1-G5, Johnson Spring 2018 Membre de l'équipe Baylor, Team S1-G5, Johnson Spring 2018

BU-JOHNSON-S18S1G5

3 membres

6 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 2

30 derniers jours : 14

Total : 80