Introduction

This guide will show you the steps to remove the headband.

Pièces

Aucune pièce nécessaire.

Remove the two screws on the underside of the headband with the PH0 Phillips screw driver.
  • Remove the two screws on the underside of the headband with the PH0 Phillips screw driver.

Ajouter un commentaire

With the headband fully extended, hold the base of the headband with one hand and with your other hand, hold the top of the headband.
  • With the headband fully extended, hold the base of the headband with one hand and with your other hand, hold the top of the headband.

  • With force, pull upwards.

Ajouter un commentaire

  • Remove the rail-piece that is now sticking up by pulling it up and out of the headphone.

  • Repeat on the opposite side and the headband will be released.

  • During reassembly, make the sure the rail-pieces match their respective sides so the headband reinserts properly.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Garrett Leung

Membre depuis le 16/04/2013

871 Réputation

8 tutoriels rédigés

Équipe

Cal Poly, Team 10-40, Amido Spring 2013 Membre de l'équipe Cal Poly, Team 10-40, Amido Spring 2013

CPSU-AMIDO-S13S10G40

4 membres

15 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 1

7 derniers jours : 3

30 derniers jours : 9

Total : 482