Introduction

How to remove the processor from the logic board.

  1. Pull on outer latch. Lower door until it is level with your work surface.
    • Pull on outer latch.

    • Lower door until it is level with your work surface.

    • Before working on the computer make sure it is not plugged into a power supply, then touch a metal object. This discharges static electricity, which could damage the computer.

  2. Use the spudger to pry the clips horizontally off of the heat sink. Fully remove the clips by lifting upwards.
    • Use the spudger to pry the clips horizontally off of the heat sink.

    • Fully remove the clips by lifting upwards.

  3. %Livraison gratuite pour toute commande supérieure à 100 $US ou contenant un Pro Tech Toolkit !

    Parcourez notre boutique
  4. Remove the heat sink by pulling upwards, off of the logic board.
    • Remove the heat sink by pulling upwards, off of the logic board.

  5. Remove the 3 screws attaching the processor to the logic board using the Phillips #2 screwdriver. Remove processor by pulling vertically upwards.
    • Remove the 3 screws attaching the processor to the logic board using the Phillips #2 screwdriver.

    • Remove processor by pulling vertically upwards.

Ligne d'arrivée

12 autre(s) ont terminé cette réparation.

Justin Petrilli

Membre depuis le 21/01/2010

2 652 Réputation

11 tutoriels rédigés

Équipe

Cal Poly, Team 13-24, Maness Winter 2010 Membre de l'équipe Cal Poly, Team 13-24, Maness Winter 2010

CPSU-MANESS-W10S13G24

4 membres

18 tutoriels rédigés

anyone still sell the replacement processor?

Joseph Cole - Réponse

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 4

30 derniers jours : 22

Total : 10,543