Introduction

This guide will show you how to remove and replace the Video Adapter in your Power Mac 4 Quicksilver.

Pièces

Aucune pièce nécessaire.

  1. The handle to open your computer is located on top of the right side panel.
    • The handle to open your computer is located on top of the right side panel.

    Ajouter un commentaire

  2. Grab the circular handle and pull outward.
    • Grab the circular handle and pull outward.

    Ajouter un commentaire

    • Your computer is now open and ready for repair.

    Ajouter un commentaire

    • This is your Power Mac G4's video adapter.

    Ajouter un commentaire

    • Start by removing the screw holding the card to the chassis as shown.

    Ajouter un commentaire

    • Before lifting the card out, this small plastic tab needs to be pulled back there by releasing it entirely.

    Ajouter un commentaire

    • With the tab and screw removed, lift the card straight out.

    • When putting the card back in, take care to apply even pressure across the top with your thumbs. This will avoid damaging the card.

    Ajouter un commentaire

    • Your card is now completely removed and ready to be replaced.

    Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

5 autre(s) ont terminé cette réparation.

Cameron Christensen

Membre depuis le 20/01/2010

522 Réputation

3 tutoriels rédigés

Équipe

Cal Poly, Team 14-41, Regan Winter 2010 Membre de l'équipe Cal Poly, Team 14-41, Regan Winter 2010

CPSU-REGAN-W10S14G41

4 membres

10 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 2

30 derniers jours : 12

Total : 6,430