Introduction

This guide includes instructions on how to remove and replace the D-Pad button from the PowerA Spectra controller.

The D-Pad is a plus-symbol-shaped button that allows for four different inputs. The button can usually fail to work because of dirt buildup in the button itself.

Make sure to disconnect the controller from any electrical sources before beginning.

Ce dont vous avez besoin

Étape 1 Rear Case

PowerA Spectra Contoller D-Pad Replacement, Rear Case: étape 1, image 1 de 1

Flip the controller over so the backplate is facing up.

Modifier

Étape 2

Use a Phillips #2 screwdriver to remove the eight 7.8 mm screws that secure the rear case.

Modifier

Étape 3

Hold the front case in one hand and pull the rear case off.

Modifier

Étape 4 D-Pad

PowerA Spectra Contoller D-Pad Replacement, D-Pad: étape 4, image 1 de 1

Use a Phillips screwdriver to remove the two 7.8 mm screws securing the motherboard to the chassis.

Modifier

Étape 5

Gently take the motherboard off of the front plate.

Modifier

Étape 6

Use Phillips screwdriver to remove the four 7.8 mm screws that secure the D-pad.

Modifier

Étape 7

Gently pry off the D-pad.

Modifier

Conclusion

To reassemble your device, follow the above steps in reverse order.
Repair didn’t go as planned? Try some basic troubleshooting or ask our Answers community for help.