Aller au contenu principal

Introduction

Install an Airport Extreme 802.11g card internally.

Pièces

  1. Use a coin to turn the battery locking screw 90 degrees clockwise.
    • Use a coin to turn the battery locking screw 90 degrees clockwise.

    • Lift the battery out of the computer.

  2. Flip down the door on the right side of the battery compartment.
    • Flip down the door on the right side of the battery compartment.

  3. Use a spudger or flathead screwdriver to disconnect the Airport antenna from the card.
    • Use a spudger or flathead screwdriver to disconnect the Airport antenna from the card.

  4. Grasp the plastic tab and pull the card out all the way.
    • Grasp the plastic tab and pull the card out all the way.

Conclusion

To reassemble your device, follow these instructions in reverse order.

14 autre(s) ont terminé cette réparation.

Pièces jointes

iRobot

Membre depuis le 24/09/2009

1 Réputation

624 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 2

30 derniers jours : 5

Total : 16,690