Cette version peut contenir des modifications incorrectes. Passez au dernier aperçu vérifié.
Ce dont vous avez besoin
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Locate the battery release tab on the underside of the G4.
-
Slide the battery release tab to the left and lift the battery out of the computer.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Remove the seven T8 Torx screws from the lower case.
-
Using your thumbs, slide the lower case toward the front of the computer.
-
The lower case may stick in the front on a tab just above the center of the optical drive. Be careful as you work the case off, or you may break the thin strip of plastic just above the drive.
-
Lift the lower case off.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Disconnect the orange optical drive, modem and inverter cables from the logic board, removing tape as necessary.
-
Disconnect the two-wire pink and white inverter cable from the inverter board.
-
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Lift of the right side of the optical drive and disconnect the modem cable.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Lift the optical drive up and out of the computer.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Disconnect the multicolor cable from the PRAM battery.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Use a spudger to pry the PRAM battery out of its housing on the upper case. Make sure not to bend the PRAM battery too much while prying it out.
-
Annulation : je n'ai pas terminé ce tutoriel.
12 autres ont terminé cette réparation.
Pièces jointes
2 commentaires
Thanks..
Great instructions.
Now to find a M6091 main battery.
does a lubricant help reduce the tension on the screen mounts. ? I read these easily break.
I lubricated my screen hinges some years ago. It did help, but I should probably do it again. I think I used a very thin silicone or aromatics WD-40 type of spray, and carefully attempted to pry open the gap of the hinge to facilitate the ingress of the lube, maybe using an Opinel knife or a Stanley blade. Apologies for flaky memory. My hinges are still a dangerously weak point, and I always open the laptop carefully and slowly with two hands. Good luck.
sqeeezy -
