Cette version peut contenir des modifications incorrectes. Passez au dernier aperçu vérifié.
Ce dont vous avez besoin
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Use a Torx T3 screwdriver to unscrew the four 3.5 mm Torx T3 screws holding the back plate.
-
Remove the back plate.
-
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
The plastic frame is clipped inside the steel body with four clips, two each on the left and the right side of the watch, near the corners. You can stick a small screwdriver into the cutouts right above the clips and gently lever the plastic frame up, corner by corner.
-
Once the clips are released, use a pair of tweezers to grab onto the black plastic frame and remove the internal hardware.
-
Use tweezers or a plastic opening tool to disconnect the ribbon cable from the motherboard.
-