Aller au contenu principal

Introduction

This guide will walk you through how to remove the pinion gear from the motor shaft. Minimal tooling is required on the prerequisite steps, but removing the pinion gear itself requires no tools. Removing the pinion gear is very easy and should only take a few seconds to complete.

Pièces

Aucune pièce spécifiée.

  1. Remove the chrome shaft cover by lightly pulling it away from the drone.
    • Remove the chrome shaft cover by lightly pulling it away from the drone.

  2. Using a Phillips #000 screwdriver, remove the 7mm screw from the propeller stop.
    • Using a Phillips #000 screwdriver, remove the 7mm screw from the propeller stop.

    • Be sure to apply adequate pressure when removing the screw to prevent stripping it out.

  3. Remove the propeller stop from shaft by lightly pulling it away from the drone.
    • Remove the propeller stop from shaft by lightly pulling it away from the drone.

  4. Fix Kits pour batteries d'iPhone

    Seulement $29.99

    Buy Now

    Fix Kits pour batteries d'iPhone

    Seulement $29.99

    Buy Now
  5. Remove the propeller from shaft by lightly pulling it away from the drone.
    • Remove the propeller from shaft by lightly pulling it away from the drone.

  6. Remove the 8mm long Phillips #0 screws (24 total) from the lower housing unit. Take care to place the screws in a safe place to prevent losing them.
    • Remove the 8mm long Phillips #0 screws (24 total) from the lower housing unit.

    • Take care to place the screws in a safe place to prevent losing them.

  7. Separate the upper and lower housing units by lightly pulling the two housing units apart.
    • Separate the upper and lower housing units by lightly pulling the two housing units apart.

  8. Lift the pinion gear off the motor shaft by lightly pulling it away from the drone.
    • Lift the pinion gear off the motor shaft by lightly pulling it away from the drone.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Matthew Selting

Membre depuis le 15/02/2018

411 Réputation

4 tutoriels rédigés

Équipe

UW Stout, Team S8-G4, Ogden Spring 2018 Membre de l'équipe UW Stout, Team S8-G4, Ogden Spring 2018

UWSTOUT-OGDEN-S18S8G4

4 membres

6 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 3

Total : 54