1. Remove the top bar by removing the 5cm hex T10 screws on the back of the device as shown. Then gently pull off the top bar from the main component. Remove the top bar by removing the 5cm hex T10 screws on the back of the device as shown. Then gently pull off the top bar from the main component.
    • Remove the top bar by removing the 5cm hex T10 screws on the back of the device as shown. Then gently pull off the top bar from the main component.

  2. Remove the 1.2 cm hex T9 screws and gently open up the device. Remove the 1.2 cm hex T9 screws and gently open up the device.
    • Remove the 1.2 cm hex T9 screws and gently open up the device.

  3. %Livraison gratuite pour toute commande supérieure à 100 $US ou contenant un Pro Tech Toolkit !

    Parcourez notre boutique
  4. Detach the camera cover from the motherboard. Be very careful to not damage any of the components on the motherboard. Detach the camera cover from the motherboard. Be very careful to not damage any of the components on the motherboard.
    • Detach the camera cover from the motherboard. Be very careful to not damage any of the components on the motherboard.

  5. Use a plastic spudger to push the black sliding cable connector away from the white bracket. Use a plastic spudger to push the black sliding cable connector away from the white bracket.
    • Use a plastic spudger to push the black sliding cable connector away from the white bracket.

  6. Gently remove the ribbon cable from the connector.
    • Gently remove the ribbon cable from the connector.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Brian Maulucci

Membre depuis le 10/09/2018

581 Réputation

4 tutoriels rédigés

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 0

Total : 79