Introduction

This guide will instruct on how to replace a malfunctioning Viewfinder assembly on the RCA CC310.

Pièces

Aucune pièce nécessaire.

Slide a spudger between the plastic rail and the metal tab on the left side of the rail.  Push away from the camcorder to release the flap. Pushing the viewfinder assembly to the right makes lifting the flap easier.
  • Slide a spudger between the plastic rail and the metal tab on the left side of the rail. Push away from the camcorder to release the flap.

  • Pushing the viewfinder assembly to the right makes lifting the flap easier.

  • Slide the lifted flap towards the viewfinder assembly until the viewfinder is free from the rail.

Ajouter un commentaire

Unscrew the 7mm ph#0 screw on the underside where the cable connects. Lift the plastic where the cable connects off of the viewfinder assembly. Disconnect the cable inside by pulling it apart.
  • Unscrew the 7mm ph#0 screw on the underside where the cable connects.

  • Lift the plastic where the cable connects off of the viewfinder assembly.

  • Disconnect the cable inside by pulling it apart.

Ajouter un commentaire

Unscrew two 7.0mm ph#0 screws on the underside of the viewfinder assembly. Lift the viewfinder plastic assembly up and remove.
  • Unscrew two 7.0mm ph#0 screws on the underside of the viewfinder assembly.

  • Lift the viewfinder plastic assembly up and remove.

Ajouter un commentaire

Flip back the viewfinder access tab.
  • Flip back the viewfinder access tab.

  • Unscrew the 7.0mm ph #0 screw next to the mirror.

Ajouter un commentaire

Lift off both sides of the plastic assembly. When reassembling, if the housing doesn't connect properly, try turning the focus wheel. When reassembling, if the housing doesn't connect properly, try turning the focus wheel.
  • Lift off both sides of the plastic assembly.

  • When reassembling, if the housing doesn't connect properly, try turning the focus wheel.

Ajouter un commentaire

Lift the microphone circuit board straight up. Unclip the cable connected to the circuit board.
  • Lift the microphone circuit board straight up.

  • Unclip the cable connected to the circuit board.

Ajouter un commentaire

Lift plastic housing and guide the wires from underneath. Lift out the entire circuit board and viewfinder. Replace entire circuit board and viewfinder assembly.
  • Lift plastic housing and guide the wires from underneath.

  • Lift out the entire circuit board and viewfinder.

  • Replace entire circuit board and viewfinder assembly.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Oliver Adams

Membre depuis le 19/01/2011

620 Réputation

6 tutoriels rédigés

Équipe

Cal Poly, Team 5-20, Amido Winter 2011 Membre de l'équipe Cal Poly, Team 5-20, Amido Winter 2011

CPSU-AMIDO-W11S5G20

4 membres

7 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 3

Total : 1,656