Introduction

This guide demonstrates how to remove and replace a rear rack from the Raleigh M20 bicycle. This requires the removal of the old rear rack before replacing the new rear rack.

Pièces

Make sure that the bike is upright and stable.
  • Make sure that the bike is upright and stable.

  • With both hands, place the rear rack on the rear wheel of the bike. Take note of where the rear rack will attach on the bike.

  • Make sure that the rear rack is fitted on the bike.

Ajouter un commentaire

Place a screw to attach the rear rack to the frame of the tire.
  • Place a screw to attach the rear rack to the frame of the tire.

  • Tighten the screw with a philips screwdriver by turning it in a clockwise direction.

  • Repeat the steps above on the other side of the bike.

Ajouter un commentaire

  • Place the metal holder to be even with the bar sticking out of the rear rack.

  • Line up the holes. Place a bolt to attach them together.

  • Use a philips screwdriver to tighten the bolts.

  • Do this for both sides.

Ajouter un commentaire

  • Make sure that the rear rack is even. If it is not, redo the previous step.

  • Locate the screws on top of the rear rack. Tighten the screws using a philips screwdriver.

  • Once the screws are tightened, you are done.

Ajouter un commentaire

Conclusion

To detach the rear rack, follow the instructions of this guide in the reverse order.

Une autre personne a terminé cette réparation.

Alyssa Compania

Membre depuis le 26/09/2012

86 Réputation

1 tutoriel rédigé

Équipe

Cal Poly, Team 7-49, Forte Fall 2012 Membre de l'équipe Cal Poly, Team 7-49, Forte Fall 2012

CPSU-FORTE-F12S7G49

5 membres

5 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 2

30 derniers jours : 14

Total : 2,336