Introduction

Before removing the crank arms, the pedals must be removed first. Follow this guide to the crank arms to replace the chain guard. To reassemble the crank arms and chain guard, follow steps in reverse order.

  1. First take an 8 in adjustable crescent wrench and fit it around the base of the pedal.
    • First take an 8 in adjustable crescent wrench and fit it around the base of the pedal.

    Ajouter un commentaire

  2. To unscrew the chain side pedal twist the the wrench counter  clockwise.
    • To unscrew the chain side pedal twist the the wrench counter clockwise.

    • To unscrew the pedal that is on the side away from the chain, twist the wrench clockwise.

    Ajouter un commentaire

    • Continue turning the wrench until the pedal detaches from the crank arm.

    Ajouter un commentaire

    • Use a flathead screwdriver to remove the cap over the screw.

      • Do this for both sides.

    Ajouter un commentaire

    • To unscrew crank-arms, position socket wrench onto screw.

    • Twist the socket wrench clockwise until the screw has been removed.

    Ajouter un commentaire

    • Insert the crank arm puller into the hole that the screw was occupying.

    • Use a crescent wrench to tighten the crank arm puller by twisting clockwise until the puller cannot be tightened further.

    • Do not over tighten the crank arm puller. Once it begins to become hard to tighten, stop.

    Ajouter un commentaire

    • Turn the crank arm puller clockwise until the crankarm pops off.

    • There will be some resistance when taking the crank arm off.

    • Repeat steps 2-4 on the other side of the bike to remove the other crank arm.

    Ajouter un commentaire

    • Flip the crank arm, that has the chain-guard on it, over so that the chainring shows.

    • Locate the four screws on the back of the chain ring.

    Ajouter un commentaire

    • Use a Phillips head screwdriver to remove the four screws on the back of the chain ring.

    Ajouter un commentaire

    • Flip chain guard back over so that the chain guard faces you.

    Ajouter un commentaire

    • Grasp the crankarm in one hand and the chain guard in the other.

    • Gently, pull out and up on the chain guard until the guard pops off.

    Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

If you are replacing the chain guard, use the new chain guard when reassembling the device.

Carl Lind

Membre depuis le 26/09/2012

49 Réputation

1 tutoriel rédigé

Équipe

Cal Poly, Team 7-49, Forte Fall 2012 Membre de l'équipe Cal Poly, Team 7-49, Forte Fall 2012

CPSU-FORTE-F12S7G49

5 membres

5 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 1

30 derniers jours : 12

Total : 2,632