Introduction

This guide will give a step by step walkthrough of how to replace an old seat cushion with a new one.

  1. Loosen the seat clamp by pulling the black lever away from the frame. Once this is done, simply rotate the lever counter-clockwise to loosen the seat.
    • Loosen the seat clamp by pulling the black lever away from the frame. Once this is done, simply rotate the lever counter-clockwise to loosen the seat.

    • Stand on the right side of the bike while loosening the lever and make sure the bike isn't upside-down. This will prevent the seat from falling off during this process.

    Ajouter un commentaire

  2. Now that the seat is loosened, slowly pull up on the seat cushion until it is fully out of the frame. Next, place the seat on the ground.
    • Now that the seat is loosened, slowly pull up on the seat cushion until it is fully out of the frame. Next, place the seat on the ground.

    Ajouter un commentaire

    • Use an Allen wrench to unscrew the bolt that is holding the post to the seat cushion.

    Ajouter un commentaire

    • Now that the bolt is loosened, carefully pull the seat cushion from the post. Next remove the two riders as shown in the second image.

    Ajouter un commentaire

Conclusion

Now you are ready to reassemble the seat with your new cushion. Just follow these same steps in the reverse order. Thanks for taking the time to use this guide!

Une autre personne a terminé cette réparation.

Dante Bozzini

Membre depuis le 26/09/2012

35 Réputation

1 tutoriel rédigé

Équipe

Cal Poly, Team 7-49, Forte Fall 2012 Membre de l'équipe Cal Poly, Team 7-49, Forte Fall 2012

CPSU-FORTE-F12S7G49

5 membres

5 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 31

Total : 1,501