Cette version peut contenir des modifications incorrectes. Passez au dernier aperçu vérifié.
Ce dont vous avez besoin
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Use the blunt end of the spudger to pry the adhesive rubber pads from the top left and right edges.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Use a Phillips #0 screwdriver to remove two 6.7 mm screws.
-
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Use your fingers to identify the location of the screw under the bottom label.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Use a Phillips #0 screwdriver to remove one 6.7 mm screw.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Turn the mouse over so the bottom is facing down.
-
Separate the top casing from the bottom base by pulling the top casing upwards.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Disconnect the ribbon connector between the motherboard and the LED lights by pulling upward.
-