Introduction

The strum bar sensor board will often wear and stop working over time due to overuse. This guide demonstrates how to replace the strum bar sensor board.

Pièces

Aucune pièce nécessaire.

Remove the strap by pulling it off of the mounts located on the body and neck.
  • Remove the strap by pulling it off of the mounts located on the body and neck.

Ajouter un commentaire

Remove the nine 12mm Phillips #1 screws around the perimeter of the case with a  screwdriver.
  • Remove the nine 12mm Phillips #1 screws around the perimeter of the case with a screwdriver.

  • Remove the two 15mm Phillips #1 screws connecting the body panel to the neck panel with a screwdriver.

  • Pull off the rear case.

Ajouter un commentaire

  • Remove the five 12mm Phillips #1 screws along the neck with a screwdriver.

  • Pull off the top shell of the neck to expose the internal features.

Ajouter un commentaire

  • Use a screwdriver to remove the four 14mm Phillips #1 screws around the perimeter of the strum bar sensor board.

  • Lift up on the strum bar sensor board to remove it from the case.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Riley

Membre depuis le 18/04/2018

565 Réputation

7 tutoriels rédigés

Équipe

Cal Poly, Team S17-G1, Livingston Spring 2018 Membre de l'équipe Cal Poly, Team S17-G1, Livingston Spring 2018

CPSU-LIVINGSTON-S18S17G1

4 membres

10 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 1

7 derniers jours : 10

30 derniers jours : 51

Total : 98