Introduction

The whammy bar sensor is directly responsible for the performance of the whammy bar. This guide demonstrates how to remove the whammy bar sensor and diagnose issues with the whammy bar that were not obvious from its removal.

Pièces

Aucune pièce nécessaire.

Remove the strap by pulling it off of the mounts located on the body and neck.
  • Remove the strap by pulling it off of the mounts located on the body and neck.

Ajouter un commentaire

Remove the nine 12mm Phillips #1 screws around the perimeter of the case with a  screwdriver.
  • Remove the nine 12mm Phillips #1 screws around the perimeter of the case with a screwdriver.

  • Remove the two 15mm Phillips #1 screws connecting the body panel to the neck panel with a screwdriver.

  • Pull off the rear case.

Ajouter un commentaire

  • Remove the five 12mm Phillips #1 screws along the neck with a screwdriver.

  • Pull off the top shell of the neck to expose the internal features.

Ajouter un commentaire

  • Remove the two 7mm Phillips #0 screws.

  • Using your fingers, remove the black wire retainer.

Ajouter un commentaire

  • Using one hand, remove the whammy bar and its attached components from the case.

Ajouter un commentaire

  • Using two hands, remove the whammy bar sensor.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Riley

Membre depuis le 18/04/2018

565 Réputation

7 tutoriels rédigés

Équipe

Cal Poly, Team S17-G1, Livingston Spring 2018 Membre de l'équipe Cal Poly, Team S17-G1, Livingston Spring 2018

CPSU-LIVINGSTON-S18S17G1

4 membres

10 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 1

7 derniers jours : 3

30 derniers jours : 11

Total : 37