Introduction

In order to perform any sort of repair on the throttle body unit, it must first be removed from the engine by following these step by step instructions

Pièces

Aucune pièce nécessaire.

Firstly Disconnect  battery
  • Firstly Disconnect battery

    • Always take the negative terminal off first.

    • '''General Tip After disconnecting the battery leave the car for about 10 mins , This lets any residual energy left in the electrical system to dissapate. It is good practise whatever the job

Ajouter un commentaire

Locate throttle body on right side of engine, it is between the intake tube and intake manifold.
  • Locate throttle body on right side of engine, it is between the intake tube and intake manifold.

Ajouter un commentaire

  • Locate throttle linkage cable assembly.

Ajouter un commentaire

  • Twist the assembly clockwise.

Ajouter un commentaire

  • Slide both slackened cables off assembly’s guides.

Ajouter un commentaire

  • Locate the two hoses on the top of the throttle body.

  • Gently lift the hoses off.

Ajouter un commentaire

  • Use a flat head screwdriver to loosen the hose clamp attaching the intake tube to the throttle body.

Ajouter un commentaire

  • Remove the intake tube from the throttle body.

Ajouter un commentaire

  • Locate wiring clip on the underside of the throttle body.

Ajouter un commentaire

  • Press down on the locking mechanism before gently removing the wiring clip.

Ajouter un commentaire

  • Locate throttle linkage arm.

  • Open the locking clip with a flat head screwdriver.

  • Pry off the linkage arm with a flat head screwdriver.

Ajouter un commentaire

  • Locate the three 13mm nuts attaching the throttle body to the intake manifold.

  • Remove nuts with a 13mm crescent wrench.

Ajouter un commentaire

  • Lift the throttle body off of the intake manifold.

  • The manifold is now out of the engine bay and ready for cleaning or adjustment.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Une autre personne a terminé cette réparation.

Raymond

Membre depuis le 11/10/2010

61 Réputation

2 tutoriels rédigés

Équipe

Cal Poly, Team 3-28, Regan Fall 2010 Membre de l'équipe Cal Poly, Team 3-28, Regan Fall 2010

CPSU-REGAN-F10S3G28

4 membres

9 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 5

30 derniers jours : 33

Total : 3,615