Cette version peut contenir des modifications incorrectes. Passez au dernier aperçu vérifié.
Ce dont vous avez besoin
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Place your device upside down and locate the battery compartment.
-
Find the Phillips head screw securing the battery cover in the bottom right hand corner of the device.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Slowly remove the battery cover with the iFixit opening tool.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Use the iFixit opening tool to carefully pry the battery out of the case.
-
After the old battery is removed replace it with a new battery facing the same direction as when the cover was opened.
-
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Remove the following seven screws that secure the lower case to the DS Lite:
-
Three silver tri-wing screws (5mm long)
-
One black tri-wing screw (4mm)
-
Two gold Phillips screws (4mm)
-
One silver Phillips screw (3mm)
-
Do not remove the silver PH screw (3mm) in the battery compartment yet. It holds the main PCB in place.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
On the front edge of the Nintendo DS between the headphone jack plug and volume controls remove the plastic insert (or cartridge) from the lower slot (Slot 2).
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Flip the unit over so that it is facing right-side up.
-
Use a spudger to pry open the gap between the bottom case and the front panel. Work all the way around the case until the panel is free.
-
Avoid touching the L and R shoulder buttons, because they easily detach and are difficult to reassemble. Keep the bottom case flat against your workbench to help hold the shoulder buttons in place.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Carefully separate the two pieces by hand.
-
The two shoulder buttons are made up of three pieces -- the plastic button, a pin, and a spring. If they accidentally pop out while you are working, study the picture and make sure you put the spring in the correct position.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
After taking the bottom case off, remove two Phillips #00 screws that secure the logic board to the plastic case.
-
Annulation : je n'ai pas terminé ce tutoriel.
Une autre personne a terminé cette réparation.