Introduction

Use this guide to remove the camera's outer case in order to gain access to and repair other parts.

Pièces

Aucune pièce nécessaire.

Locate the 2 screws on the bottom of the slider.
  • Locate the 2 screws on the bottom of the slider.

  • Remove both screws with a #00 Phillips screwdriver.

Ajouter un commentaire

Gently pull on the bottom of the slider until it comes off the lower track.
  • Gently pull on the bottom of the slider until it comes off the lower track.

  • There is a little piece that connects the slider to the track. Be sure not to lose this as it is needed to put the slider back on.

Ajouter un commentaire

  • Lift the slider up until it comes off the upper track.

Ajouter un commentaire

  • The slider should now be free from the body of the camera.

Ajouter un commentaire

  • Locate the 3 screws on the outer metal band and remove them with a #00 Phillips screwdriver.

Ajouter un commentaire

  • Use the spudger to peel off the outer metal band, starting from the bottom of the camera.

  • The metal band it attached to the camera with glue in addition to screws. Be careful not to bend the band when removing it from the camera.

Ajouter un commentaire

  • The shutter button can now be removed. It is not connected to the camera and can be lifted off.

Ajouter un commentaire

  • Remove the memory card.

  • Locate and remove the 2 screws using a #00 Phillips screwdriver.

Ajouter un commentaire

  • Use a spudger around the edge of the case to loosen it.

  • Carefully wiggle the back case off. This may require a fair amount of force.

Ajouter un commentaire

  • Locate the 3 internal screws holding on the front of the case. Remove them with a #00 Phillips screwdriver.

Ajouter un commentaire

  • While grasping the interior and the front case, gently pull until they start to come apart. Some light wiggling may be required.

  • Be careful not to completely pull the front case off because it will still be connected with wires.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Jared Ruekberg

Membre depuis le 15/04/2010

24 Réputation

2 tutoriels rédigés

Équipe

Cal Poly, Team 6-13, Maness Spring 2010 Membre de l'équipe Cal Poly, Team 6-13, Maness Spring 2010

CPSU-MANESS-S10S6G13

5 membres

9 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 3

Total : 2,065