Introduction
Les batteries des ordinateurs portables se dégradent au fil du temps. Ce phénomène peut être accéléré par une utilisation constante, une exposition à des températures extrêmes ou une surcharge.
Si l'ordinateur portable a du mal à maintenir la charge ou ne parvient pas à être chargé, il est temps d'envisager le remplacement de la batterie. Le remplacement de la batterie peut être une méthode économique pour prolonger la durée de vie de l'ordinateur portable, tout en étant simple à réaliser.
Ce tutoriel fournit des instructions sur le remplacement de la batterie du HP Spectre x360 13-ac023dx et fournit une liste des pièces et des outils nécessaires.
Si la batterie est chaude ou qu'une odeur s'en dégage, n'essayez pas de la retirer et prenez les précautions appropriées.
Avant de commencer la tâche, débranchez le chargeur de l'ordinateur portable et éteignez l'ordinateur et lisez cet article sur la sécurité.
Ce dont vous avez besoin
-
-
Retournez l'ordinateur de manière à ce que l’étiquette de modèle soit orientée vers le haut
-
Pour réassembler votre appareil suivez ces instructions en ordre inverse
Pour réassembler votre appareil suivez ces instructions en ordre inverse
Annulation : je n'ai pas terminé ce tutoriel.
5 autres ont terminé cette réparation.
Merci à ces traducteurs :
100%
Ces traducteurs nous aident réparer le monde ! Vous voulez contribuer ?
Commencez à traduire ›
5 commentaires de tutoriel
The overall procedure is ok, however as others commented instructions on how to remove the feet would be helpful. I tried a heat gun to help loosen the glue, however that just melted the feat. Overall go the job done, but 2 out of the 4 feet were destroyed in the process.
Also in my case there were no screws under the top or bottom feet, so I could have probably removed the cover without removing the feet.
I think HP quietly refreshed the internals of this laptop or something, because despite appearing externally identical to the laptop shown in the pictures, mine has a smaller main board and differently sized battery. so you should open yours up and check before ordering the battery. mine has the PK03XL. this is double annoying because I was repairing this one for a friend, and she's the one who ordered the battery.
just finished my repair of my w-013 version. good to know that the top two feet have screws underneath them - small risk of denting the bottom cover if you're not gentle. also, the cable is slightly too long to fit neatly in the battery receptacle - it required some jamming that i'll probably be concerned about for a while.
This guide was helpful but my bottom two feet didn't have screws. I used a T4 instead of T5 and for the Phillips a T0 and a T1.
The battery had two metal stickers on it under the bottom feet so I put them on the replacement battery in the same place.
My model is 13-ac033dx