Réparez vos affaires Communauté Boutique

Repairing Black and Decker BL3000S Power Cord

Ce dont vous avez besoin

  1. Repairing Black and Decker BL3000S Power Cord, Blender Base: étape 1, image 1 de 2 Repairing Black and Decker BL3000S Power Cord, Blender Base: étape 1, image 2 de 2

    • Before disassembling the blender base, make sure the blender disconnected from any power outlet.

    • Lift the jar straight up from the base without tilting the jar.

    Traduire

  2. Repairing Black and Decker BL3000S Power Cord: étape 2, image 1 de 1

    • Remove the top three 1/4 inch base screws using a Philip's head screwdriver.

    Traduire

  3. Repairing Black and Decker BL3000S Power Cord: étape 3, image 1 de 2 Repairing Black and Decker BL3000S Power Cord: étape 3, image 2 de 2

    • Remove the two base leg covers next to the power cord using pliers or a flat-head screwdriver.

    • This provides access to the base screws beneath.

    Traduire

  5. Repairing Black and Decker BL3000S Power Cord: étape 4, image 1 de 1

    • Remove the following screws that secure the top and bottom halves of the base.

    • One 1/4 Phillips screw

    • One TA-20 screw

    • Both screwdrivers must have a minimum of a three inch shank (length).

    • Screwdrivers with extenders will not fit down the access holes.

    Traduire

  6. Repairing Black and Decker BL3000S Power Cord: étape 5, image 1 de 1

    • Lift the top half of the base from the bottom half of the base to reveal the internal mechanism.

    Traduire

  7. Repairing Black and Decker BL3000S Power Cord, Power Cord: étape 6, image 1 de 1

    • Tug on wires in the marked locations to make sure they are secure.

    • If the wire stays still, the connection is secure.

    • If you still have problems with the blender, it is probably a problem with the motor. Since the motor is irreplaceable, you will have to order a new blender.

    Traduire

  8. Repairing Black and Decker BL3000S Power Cord: étape 7, image 1 de 1

    • If the wire comes off, the connection is insecure. You will need to solder the connection to make it solid again.

    • If you don't know how to solder, here is a link to show you how. http://www.aaroncake.net/electronics/sol...

    Traduire
Conclusion

To reassemble your device, follow these instructions in reverse order.

4 autres ont terminé cette réparation.

Auteur

avec 2 autres contributeurs

Elmer Pres Urbano

Membre depuis le 10/05/12

148 Réputation

1 tutoriel rédigé

Badges: 9

+ 6 badges supplémentaires

Équipe

Cal Poly, Team 6-34, Regan Fall 2012 Membre de l'équipe Cal Poly, Team 6-34, Regan Fall 2012

CPSU-REGAN-F12S6G34

4 membres

6 tutoriels rédigés

0 commentaires

Ajouter un commentaire

Nombre de vues :

Dernières 24 heures : 0

7 derniers jours : 9

30 derniers jours : 38

Total : 3,878