Introduction

This guide will show how to replace the speaker on the Casio camera

Pièces

Aucune pièce nécessaire.

  1. Remove the four screws on the side with the speaker
    • Remove the four screws on the side with the speaker

    Ajouter un commentaire

  2. Remove the four screws from the bottom of the camera.
    • Remove the four screws from the bottom of the camera.

    • Note: Bottom screws are longer than the top ones, so label accordingly for easy reassembly

    Ajouter un commentaire

    • Remove the four screws on the side opposite of the speaker.

    Ajouter un commentaire

    • Pull apart the bottom casing.

    Ajouter un commentaire

    • Remove ribbon from the rear casing.

    • Set aside rear casing.

    Ajouter un commentaire

  3. Livraison gratuite pour les commandes de plus de 20 $
    Indiquez le code BLUEANDBLACK au moment de payer
    Livraison gratuite pour les commandes de plus de 20 $
    Indiquez le code BLUEANDBLACK
    • Use tweezers or prongs to pry the LCD screen off from the opening.

    • Note: The bottom of the LCD screen is attached to the frame by a few pieces of black tape.

    Ajouter un commentaire

    • Lift up the LCD screen, slowly move it to the other side.

    Ajouter un commentaire

    • Pry off the LCD casing which is taped on to the frame.

    Ajouter un commentaire

    • Flip open the connector holding the ribbon.

    • Pull out the LCD screen with the ribbon from the camera.

    Ajouter un commentaire

    • Pull apart the front casing.

    Ajouter un commentaire

    • Remove two screws on the side where the battery is located.

    • Remove the lanyard loop after the screws come off.

    • Slowly pull the side casing so it becomes dislocated from the top of the camera frame.

    Ajouter un commentaire

    • On the front of the camera near the flash flip the connector holding the ribbon.

    • Remove the ribbon from the connector.

    Ajouter un commentaire

    • Carefully remove the L shaped frame from the camera

    • At the bottom of the camera the L shaped frame is being held in by two plastic bumps and a metal tab.

    • Pop the frame off the bumps and tabs.

    • Note: There is a yellow and orange wire soldered onto the camera. Be careful not to pull them off.

    • The blue box is the speaker

    Ajouter un commentaire

    • Remove the speaker with tweezers

    Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Christian

Membre depuis le 28/01/2011

320 Réputation

3 tutoriels rédigés

Équipe

Cal Poly, Team 4-38, Regan Winter 2011 Membre de l'équipe Cal Poly, Team 4-38, Regan Winter 2011

CPSU-REGAN-W11S4G38

4 membres

7 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 0

Total : 2,514