Introduction

Replace the volume switch on the DS Lite.

  1. Unscrew the Phillips screw securing the battery cover to the lower case.
    • Unscrew the Phillips screw securing the battery cover to the lower case.

    • The screw remains captive to the battery cover.

    • Pry the battery cover upward with a spudger or fingernail, and lift out of the lower case.

  2. Wedge the edge of a spudger in between the side of the battery and the lower case housing and pry upward to dislodge the battery.
    • Wedge the edge of a spudger in between the side of the battery and the lower case housing and pry upward to dislodge the battery.

    • Remove the battery from the DS Lite.

    • Use the tip of a spudger to pry both rubber feet off the DS Lite.

    • Remove the following screws securing the lower case to the body of the DS Lite:

      • Two 4.3 mm gold Phillips screws

      • One 3.9 mm black Tri-Wing screw

      • One 3.3 mm silver Phillips screw

      • Three 5.5 mm silver Tri-Wing screws

    • Insert the edge of a spudger in between the lower and upper case near the top right corner of the DS Lite.

    • Carefully run the spudger along the right edge of the DS Lite, creating an opening in the process.

    • Continue running the spudger along the backside of the DS Lite until the majority of the lower case has been separated from the upper case.

    • Lift the lower case away from the rest of the DS Lite.

    • Pull carefully. Some units are sealed with adhesive, and pulling too hard can damage the power switch.

    • Carefully use a pair of tweezers to remove the volume switch.

Ligne d'arrivée

3 autre(s) ont terminé cette réparation.

Philip

Membre depuis le 20/01/2010

436 Réputation

2 tutoriels rédigés

Équipe

Cal Poly, Team 16-30, Maness Winter 2010 Membre de l'équipe Cal Poly, Team 16-30, Maness Winter 2010

CPSU-MANESS-W10S16G30

4 membres

11 tutoriels rédigés

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 5

30 derniers jours : 28

Total : 6,025