Introduction

Sometimes during printing the paper will become jammed inside the printer. There are three places in which paper can become jammed. The following guide shows you the three different ways of removing the jammed paper depending on where the jam occurs.

Outils

Aucun outil requis.

Pièces

Aucune pièce nécessaire.

Press the front cover release button.
  • Press the front cover release button.

  • Keep the button pressed and pull the cover toward yourself.

Ajouter un commentaire

With the front cover in the downward position, the drum & toner unit will be visible.
  • With the front cover in the downward position, the drum & toner unit will be visible.

  • Grab the black-and-yellow handle on the unit. Lift unit up and pull it out of the printer.

Ajouter un commentaire

  • DO NOT TOUCH the electrodes on the right inner wall of the printer. Touching these electrodes can cause electrical damage to the printer.

Ajouter un commentaire

  • If jammed, paper will be visible after removing the drum unit. To clear paper jam, reach into printer and grab a corner of the paper.

  • Proceed to lift paper up and out of the printer.

  • Jammed paper may require an excess amount of force to be removed from printer.

Ajouter un commentaire

  • Grab onto the lift located on the paper tray near the bottom on the front of the printer.

  • Pull the paper tray completely out of the printer by pulling towards yourself.

Ajouter un commentaire

  • If jammed paper is visible, grab onto the paper and remove by pulling up and towards yourself.

  • Jammed paper may require a large amount of force to be removed from printer.

Ajouter un commentaire

  • Located on the back of the printer, open up the cover by grabbing onto the tab and pulling down.

Ajouter un commentaire

  • In front of you will see two blue tabs, one on the left and right side.

  • First, push the top part of the tab in until the bottom part of the tab lifts up.

  • Grab onto the bottom part of the tab.

Ajouter un commentaire

  • Once you have a firm grib of both the right and left tab, lift both tabs up and towards yourself.

  • The fuser cover, which the tabs are connected to, does not come completely out of the printer because it is attached to the bottom by a hinge.

Ajouter un commentaire

  • If jammed paper is visible, grab onto the top of the paper and pull up until completely removed from printer.

  • Jammed paper may require an excess amount of force to be removed from printer.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

2 autre(s) ont terminé cette réparation.

Nathan Ruiz

Membre depuis le 14/01/2010

159 Réputation

2 tutoriels rédigés

Équipe

Cal Poly, Team 4-14, Forte Winter 2010 Membre de l'équipe Cal Poly, Team 4-14, Forte Winter 2010

CPSU-FORTE-W10S4G14

5 membres

5 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 2

7 derniers jours : 11

30 derniers jours : 57

Total : 10,552