Aller au contenu principal

Réparez vos affaires

Droit à la réparation

Boutique

Introduction

This guide will show you how to get to the LEDs on your Seville Classics MSC10166 Tower Fan and how to inspect the circuit board. If there is a faulty connection or a loose wire, this guide demonstrates a quick solution.

Pièces

Aucune pièce spécifiée.

  1. Use the Philips #2 screwdriver to remove the four 6mm Phillips #0 back screws by unscrewing counterclockwise.
    • Use the Philips #2 screwdriver to remove the four 6mm Phillips #0 back screws by unscrewing counterclockwise.

  2. Pull the front and back cover apart.
    • Pull the front and back cover apart.

    • Be careful not to pull the front cover off completely. It holds the wires.

  3. Remove the Phillips 6-mm screw that holds the circuit board to the outer shell of the fan.
    • Remove the Phillips 6-mm screw that holds the circuit board to the outer shell of the fan.

    • Shock warning: Make sure the fan is unplugged before removing the circuit board.

  4. Remove the top cover containing the circuit board and the wires by pulling it away from the outer shell of the fan.
    • Remove the top cover containing the circuit board and the wires by pulling it away from the outer shell of the fan.

  5. Remove the screws from the four corners of the circuit board. Remove the circuit board from the top cover.
    • Remove the screws from the four corners of the circuit board.

    • Remove the circuit board from the top cover.

    • Do not touch the other side of the circuit board to avoid damaging the circuit elements.

  6. Shown is the top side of the printed circuit board that contains the LEDs.
    • Shown is the top side of the printed circuit board that contains the LEDs.

    • Inspect the PCB for any faulty connections or loose components.

  7. Make sure the wires on the side of the board are properly connected. If the wires have are not connected properly, re-solder them to the board using the soldering iron. If the wires have are not connected properly, re-solder them to the board using the soldering iron.
    • Make sure the wires on the side of the board are properly connected.

    • If the wires have are not connected properly, re-solder them to the board using the soldering iron.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Une autre personne a terminé cette réparation.

Queena Phung

Membre depuis le 26/09/2012

111 Réputation

3 tutoriels rédigés

Équipe

Cal Poly, Team 15-46, Forte Fall 2012 Membre de l'équipe Cal Poly, Team 15-46, Forte Fall 2012

CPSU-FORTE-F12S15G46

5 membres

6 tutoriels rédigés

Good stuff except for the fact that the most common problem(fan not working) that is for me, the first and simplest repair listed is referred to a dead end in led repair section. I could be wrong, but still, where is the fuse and how does the ohm meter work for a fuse test again? Hey, your fixer guide is the one that brought it up in the first place. Just saying.....

Finner 69 - Réponse

Agreed with Finner 69, that where is the fuse and how does the ohm meter work for a fuse test again? I have Seville Ultraslimline tower fan and fan not working. Power there.

Ava - Réponse

Ajouter un commentaire

Afficher les statistiques:

Dernières 24 heures : 1

7 derniers jours : 12

30 derniers jours : 52

Total : 5,837