Introduction

How to replace speaker

  1. Turn the phone over so that the screen is facing the work surface
    • Turn the phone over so that the screen is facing the work surface

    Ajouter un commentaire

  2. Press your thumb against the battery latch. While pressing on latch, slide off battery cover towards the bottom of the phone.
    • Press your thumb against the battery latch. While pressing on latch, slide off battery cover towards the bottom of the phone.

    • You may need to apply considerable force on the latch at the bottom of the phone to complete this successfully.

    Ajouter un commentaire

    • Remove the battery by pushing downward on the area where prongs connect to bottom inside of the phone while using a thumb, finger, or tool to pull on the top of the battery to lift it out.

    Ajouter un commentaire

    • Using the T6 Torx screwdriver, remove the bottom two screws on the back of the phone.

    Ajouter un commentaire

  3. Répandez la magie de Noël
    Obtenez 12 $ de réduction sur les commandes de 50 $ ou plus avec le code FIXMAS12
    Répandez la magie de Noël
    Obtenez 12 $ de réduction sur les commandes de 50 $ ou plus avec le code FIXMAS12
    • Remove speaker phone cover by unsecuring the two latches on the edge close to top of the phone with the plastic opening tool.

    Ajouter un commentaire

    • Detach the speaker phone cover by pulling up on the bottom of the speaker phone cover.

    • As you detach the speaker phone cover you will notice a sticky glue sealing the rubber gasket from the cover to the speaker mesh. This is normal and will correctly reset the first few times the pieces are separated.

    Ajouter un commentaire

    • Remove top two screws with T6 Torx screw driver, from the back of phone.

    Ajouter un commentaire

    • Turn the phone sideways and unlatch the hinge on one side of the phone by pushing inwards and twisting to the side with the plastic opening tool.

    Ajouter un commentaire

    • You should now be able to easily separate the phone into two pieces.

    • The battery prong may fall out when the separation occurs, just don't loose it!

    Ajouter un commentaire

    • Set aside the bottom part of the phone.

    • Drop out the rubber keypad from the top, so that it does not get in the way.

    Ajouter un commentaire

    • Use the plastic separator tool to apply significant pressure in a downward motion on the top of the white speaker unit.

    Ajouter un commentaire

    • The speaker unit should become loose.

    • You can now push the separating tool beneath the speaker and pop it out.

    • Once the defective unit is removed, pop your new speaker unit back into place.

    Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Sean Tiernan

Membre depuis le 20/01/2010

5 Réputation

5 tutoriels rédigés

Équipe

Cal Poly, Team 3-16, Maness Winter 2010 Membre de l'équipe Cal Poly, Team 3-16, Maness Winter 2010

CPSU-MANESS-W10S3G16

4 membres

5 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 0

Total : 1,082