Introduction

This guide will show you how to replace the speaker from your Atari Lynx. Before beginning, it is a must to know how to solder and desolder. In order to find out how to do these processes there will be a link in the the following steps. Aside from soldering, most steps should be easy to follow and simple.

  1. Before disassembling your Atari Lynx, be sure the device is powered off.
    • Before disassembling your Atari Lynx, be sure the device is powered off.

    • Remove any game in the console by opening the right latch and sliding the game to the right.

  2. Remove the four 35 mm Phillips #1 screws at each corner of the backside on the Atari Lynx.
    • Remove the four 35 mm Phillips #1 screws at each corner of the backside on the Atari Lynx.

    • Pinch the rear panel with your fingers and lift away from the Atari.

  3. %Livraison gratuite pour toute commande supérieure à 100,00 $US ou contenant un Pro Tech Toolkit !

    Parcourez notre boutique

    Vous avez déjà réparé quelque chose ? Vous êtes un génie.

    Partagez votre réparation avec le hashtag #ImAGenius

    Nous sommes tous des génies

    Partagez votre réparation avec le hashtag #ImAGenius

  4. Remove the battery panel by pinching the sides with your fingers and lifting it away from the Atari.
    • Remove the battery panel by pinching the sides with your fingers and lifting it away from the Atari.

    • Be sure not to tear any wires attached to battery panel.

  5. Remove the control panel by pinching the sides with your fingers and lifting  it away from the Atari.
    • Remove the control panel by pinching the sides with your fingers and lifting it away from the Atari.

    • Be sure not to tear the speaker wire while removing the control panel.

  6. Remove the logic board from the console. Flip the logic board so the screen is facing down.
    • Remove the logic board from the console.

    • Flip the logic board so the screen is facing down.

  7. Now you will need to desolder both of the wires connected to the speaker. If you are having trouble desoldering, click here.
    • Now you will need to desolder both of the wires connected to the speaker.

    • If you are having trouble desoldering, click here.

    • Finally solder the new speaker back on and follow the previous steps in reverse order.

Conclusion

To reassemble your device, follow these instructions in reverse order.

3 autre(s) ont terminé cette réparation.

Tyler Williams

Membre depuis le 26/01/2014

317 Réputation

2 tutoriels rédigés

Équipe

Cal Poly, Team 1-42, Maness Winter 2014 Membre de l'équipe Cal Poly, Team 1-42, Maness Winter 2014

CPSU-MANESS-W14S1G42

5 membres

8 tutoriels rédigés

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 1

30 derniers jours : 5

Total : 790