Introduction
In order to replace most other parts in the sander, you must remove the top cover. All you will need is a T10 screwdriver. Make sure that the device is unplugged before following this guide.
Ce dont vous avez besoin
-
-
Remove the four M3.5 x 16 mm screws from the top cover using a Torx T10 screwdriver.
-
-
Presque terminé !
To reassemble your device, follow these instructions in reverse order.
Conclusion
To reassemble your device, follow these instructions in reverse order.
Équipe
UC Davis, Team S20-G3, Lore Winter 2019 Membre de l'équipe UC Davis, Team S20-G3, Lore Winter 2019
UCD-LORE-W19S20G3
3 membres
4 tutoriels rédigés
