Réparez vos affaires Communauté Boutique

Right-Side Cover Removal

Conditions préalables uniquement
Ce tutoriel est uniquement destiné à être utilisé comme prérequis d'autres tutoriels. Il ne se suffit pas à lui-même.

Introduction

Follow this guide to remove the right-side cover of a Mi-T-M heater model MH-0190-0M10.

This is a prerequisite-only guide! This guide is part of another procedure and is not meant to be used alone.

Ce dont vous avez besoin

  1. Right-Side Cover Removal, Safety precautions: étape 1, image 1 de 2 Right-Side Cover Removal, Safety precautions: étape 1, image 2 de 2

    • Power off the machine at least one hour prior to starting repairs. Ensure the machine is completely cool to the touch.

    • Flip the power switch into the OFF position.

    • Unplug any extension cords from the included power cord.

    Traduire

  2. Right-Side Cover Removal, Remove the upper shell: étape 2, image 1 de 2 Right-Side Cover Removal, Remove the upper shell: étape 2, image 2 de 2

    • Use a 5/16 inch socket or Phillips screwdriver to remove the eight screws securing the upper shell, four on each side.

    Traduire

  4. Right-Side Cover Removal: étape 3, image 1 de 2 Right-Side Cover Removal: étape 3, image 2 de 2

    • Lift the upper shell straight up off of the machine to remove it.

    Traduire

  5. Right-Side Cover Removal, Remove the right-side cover: étape 4, image 1 de 1

    • Use a 5/16 inch socket or Phillips screwdriver to remove the four bolts securing the right-side cover.

    Traduire

  6. Right-Side Cover Removal: étape 5, image 1 de 3 Right-Side Cover Removal: étape 5, image 2 de 3 Right-Side Cover Removal: étape 5, image 3 de 3

    • Tilt the right-side cover down to access the PCB board.

    • Do not fully remove the right-side cover, it is still attached via the on/off switch.

    • During reassembly, ensure the display window is aligned with the LCD display before you press the cover into place.

    Traduire

  7. Right-Side Cover Removal: étape 6, image 1 de 3 Right-Side Cover Removal: étape 6, image 2 de 3 Right-Side Cover Removal: étape 6, image 3 de 3

    • There are two wires connecting the power switch to the main PCB assembly.

    • Use needle nose pliers to remove the wire with the blue connector.

    • Remove the wire with the clear connector.

    • Remove the right-side cover.

    • During reassembly, install the power switch wires back in their original locations with the blue wire above the clear wire.

    Traduire
Conclusion

To reassemble your device, follow these instructions in reverse order.

Auteur

avec 1 autre contributeur

Sam Omiotek

Membre depuis le 02/25/19

84 712 Réputation

290 tutoriels rédigés

Badges: 35

+ 32 badges supplémentaires

0 commentaires

Ajouter un commentaire

Nombre de vues :

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 4

Total : 5