Aller au contenu principal

Introduction

A step-by-step guide for motion detector replacement on a Ring Spotlight Cam Battery. Please be sure to follow the following steps. It will take approximately 15-30 minutes to replace the motion detector lights.

Pièces

Aucune pièce spécifiée.

  1. Turn Ring Spotlight Cam to the posterior side and flip upside down
    • Turn Ring Spotlight Cam to the posterior side and flip upside down

  2. Press down on top button and open upward
    • Press down on top button and open upward

  3. Open spotlight Cam upward and remove the two screws down the middle with a Phillips #1 screwdriver.
    • Open spotlight Cam upward and remove the two screws down the middle with a Phillips #1 screwdriver.

  4. Remove the two screws down the middle and lift the middle component off
    • Remove the two screws down the middle and lift the middle component off

  5. Remove the remaining 10 screws that are around the border under the tape.
    • Remove the remaining 10 screws that are around the border under the tape.

  6. Gently close the top of the lid
    • Gently close the top of the lid

  7. Remove the top lid and replace the LED light
    • Remove the top lid and replace the LED light

Conclusion

To reassemble your device, follow these instructions in reverse order.

Marisol Esparza

Membre depuis le 17/01/2019

1 Réputation

1 tutoriel rédigé

Ajouter un commentaire

Afficher les statistiques:

Dernières 24 heures : 0

7 derniers jours : 6

30 derniers jours : 26

Total : 356