Aller au contenu principal

Réparez vos affaires

Droit à la réparation

Pièces & Outils

Introduction

In this guide, you will be shown how to take apart the housing unit in order to replace the battery of the Ring Video Doorbell, step-by-step. You will need only a Plastic Tool Opener for this.

  1. Start by using the PH00 Phillips Screwdriver to take out the 6 1 mm screw's on the bottom of the device. Pry open the aluminium plate using the Plastic Opening Tool(s). Remove the 2 1. mm screws using the PH00 Phillips Screwdriver.
    • Start by using the PH00 Phillips Screwdriver to take out the 6 1 mm screw's on the bottom of the device.

    • Pry open the aluminium plate using the Plastic Opening Tool(s).

    • Remove the 2 1. mm screws using the PH00 Phillips Screwdriver.

  2. Kits pour Nintendo Switch

    Une solution rapide pour reprendre le jeu

    Acheter un kit pour Switch

    Kits pour Nintendo Switch

    Une solution rapide pour reprendre le jeu

    Acheter un kit pour Switch
  3. Pry open the back case as shown using the Plastic Opening Tool. Do NOT lift the case of all the way, there is still a cable connecting the two pieces. Disconnect the battery from motherboard by carefully pulling up on the connector.
    • Pry open the back case as shown using the Plastic Opening Tool.

    • Do NOT lift the case of all the way, there is still a cable connecting the two pieces.

    • Disconnect the battery from motherboard by carefully pulling up on the connector.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Une autre personne a terminé cette réparation.

Abdulrahman

Membre depuis le 20/02/2018

595 Réputation

3 tutoriels rédigés

Équipe

USF Tampa, Team S11-G5, Cheng Spring 2018 Membre de l'équipe USF Tampa, Team S11-G5, Cheng Spring 2018

USFT-CHENG-S18S11G5

3 membres

5 tutoriels rédigés

Where do I get a replacement battery?

William Price - Réponse

I had an issue where the battery would not charge the light when I was trying to charge the battery flashed bue quickly, I removed the battery and found that the connector was corroded after cleaning it and making sure it was connected correctly the battery then took a full charge and now the bell functions as intended once again.

P.S thanks for the guide :)

David Haras - Réponse

Ajouter un commentaire

Afficher les statistiques:

Dernières 24 heures : 4

7 derniers jours : 29

30 derniers jours : 99

Total : 2,266