Introduction

This guide will explain step-by-step how to replace the speaker in a Ring Video Doorbell Pro.

Start by using the star-shaped end of the included Ring screwdriver to take out the 5 mm screw on the bottom of the device.
  • Start by using the star-shaped end of the included Ring screwdriver to take out the 5 mm screw on the bottom of the device.

Ajouter un commentaire

Use your thumbs to apply downward pressure on the glass part of the device while pulling the faceplate up and off of the device.
  • Use your thumbs to apply downward pressure on the glass part of the device while pulling the faceplate up and off of the device.

Ajouter un commentaire

  • Using a PH-000 screwdriver, unscrew and set aside all four of these 5.25 mm screws.

Ajouter un commentaire

  • Using a plastic pry tool, go along the edge of the device prying the device apart. While doing this, focus on the four clips, two of which are on either side of the device.

Ajouter un commentaire

  • Remove the front of the device from the back plate.

Ajouter un commentaire

  • With the Video Doorbell Pro opened up the speaker is exposed.

Ajouter un commentaire

  • Remove this 5.25 mm screw.

Ajouter un commentaire

  • Remove this wire connection by gently prying it off with a plastic pry tool.

Ajouter un commentaire

  • Remove the speaker from the device.

Ajouter un commentaire

Conclusion

To reassemble your device, insert the new speaker and follow these instructions in reverse order.

3 autre(s) ont terminé cette réparation.

Jake Dixon

Membre depuis le 09/11/2017

572 Réputation

4 tutoriels rédigés

Équipe

IUPUI, Team S7-G4, Baechle Fall 2017 Membre de l'équipe IUPUI, Team S7-G4, Baechle Fall 2017

IUPUI-BAECHLE-F17S7G4

3 membres

4 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 5

7 derniers jours : 52

30 derniers jours : 292

Total : 1,085