Aller au contenu principal

Pièces

Aucune pièce spécifiée.

  1. Make sure the toaster is unplugged before starting. Turn the toaster upside down and remove the rubber feet.
    • Make sure the toaster is unplugged before starting.

    • Turn the toaster upside down and remove the rubber feet.

  2. Using a #2 Phillips head screwdriver, remove the four 12mm screws that attach the toaster shell. Using a #2 Phillips head screwdriver, remove the four 12mm screws that attach the toaster shell.
    • Using a #2 Phillips head screwdriver, remove the four 12mm screws that attach the toaster shell.

  3. With the dial facing you, push the toaster base up and away until the base is just over the lip of the shell. This will disconnect the browning dial from the rest of the toaster. When reassembling the toaster, make sure that the back of the dial lines up with the slot both in position and orientation (the dial and slot are not perfect  circles - they have a notch). The only object holding the shell onto the  toaster now is the grey part of the lever.
    • With the dial facing you, push the toaster base up and away until the base is just over the lip of the shell. This will disconnect the browning dial from the rest of the toaster.

    • When reassembling the toaster, make sure that the back of the dial lines up with the slot both in position and orientation (the dial and slot are not perfect circles - they have a notch).

    • The only object holding the shell onto the toaster now is the grey part of the lever.

  4. Fix Kits pour iPhone X

    Finie la garantie ? Pas de soucis, nous avons de quoi réparer.

    Acheter maintenant

    Fix Kits pour iPhone X

    Finie la garantie ? Pas de soucis, nous avons de quoi réparer.

    Acheter maintenant
  5. Reach under the shell and grab the back, white part of the lever.
    • Reach under the shell and grab the back, white part of the lever.

    • Grab the grey lever between your index finger and your middle finger and pull.

    • Pulling too hard will break the mechanism that holds the grey handle onto the white lever.

    • Remove the shell.

  6. The power wire connects to the toaster in the area highlighted. To free the wire, unscrew the two .5 inch screws, and remove the white brace.
    • The power wire connects to the toaster in the area highlighted.

    • To free the wire, unscrew the two .5 inch screws, and remove the white brace.

  7. To solder the the wire, the circuit board has to be released.
    • To solder the the wire, the circuit board has to be released.

    • To do this, unscrew the .5 inch screw located in the middle of the board.

    • Slowly lift the board up off the toaster, making sure that the red pegs that hold the board in place do not break.

  8. To reattach the wire, follow this solder guide.
    • To reattach the wire, follow this solder guide.

    • Solder Guide

Conclusion

To reassemble your device, follow these instructions in reverse order.

Grant Haug

Membre depuis le 26/09/2012

139 Réputation

4 tutoriels rédigés

Équipe

Cal Poly, Team 2-8, Propen Fall 2012 Membre de l'équipe Cal Poly, Team 2-8, Propen Fall 2012

CPSU-PROPEN-F12S2G8

5 membres

6 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 3

Total : 1,349