Aller au contenu principal

Introduction

This guide will help you replace the back cover of you controller. You’ll only need a Phillips #000 screwdriver to complete this guide.

  1. Remove the screws on the back of the controller with the Phillips #000 screwdriver. Hold the controller with the bottom plate facing up, gently remove the top plate that is connected to the motherboard of the controller. Set the top plate aside. Be sure to separate the two plates with the bottom facing up, to keep the buttons from falling out.
    • Remove the screws on the back of the controller with the Phillips #000 screwdriver.

    • Hold the controller with the bottom plate facing up, gently remove the top plate that is connected to the motherboard of the controller. Set the top plate aside.

    • Be sure to separate the two plates with the bottom facing up, to keep the buttons from falling out.

    • Place screws on magnetic project mat to avoid losing any screws.

Conclusion

To reassemble your device, follow these instructions in reverse order.

2 autres ont terminé cette réparation.

Omar Shorab

Membre depuis le 23/04/2018

261 Réputation

2 tutoriels rédigés

Équipe

Cal Poly, Team S24-G12, Maness Spring 2018 Membre de l'équipe Cal Poly, Team S24-G12, Maness Spring 2018

CPSU-MANESS-S18S24G12

4 membres

10 tutoriels rédigés

0 commentaires

Ajouter un commentaire

Nombre de vues :

Dernières 24 heures : 0

7 derniers jours : 1

30 derniers jours : 5

Total : 208