SONY SRS-X2 Battery Replacement

Introduction

Safely take apart the speaker and remove the battery for a replacement.

Ce dont vous avez besoin

Étape 1 Face Plate

SONY SRS-X2 Battery Replacement, Face Plate: étape 1, image 1 de 2

SONY SRS-X2 Battery Replacement, Face Plate: étape 1, image 2 de 2

Use the metal spudger to pry the face screen open. Pull away from the device to remove.

Modifier

Étape 2

Remove seven, 27 mm long Phillips #1 screws.
Remove three, 11mm long Phillips #1 screws.
Remove four, 10 mm long Phillips#1 screws.

Modifier

Étape 3

Before removing the host plate, face the feet of the speaker to you. The wiring allows for minimal access to the inner components.
Use the spudger to remove the speaker host plate. Insert the metal tip in the seam between the host plate and the shell.
Be very careful when pulling the speaker host plate (described in the next step) as there are wiring connected to the host plate. This wiring is soldered to the plate and to the shell of the device. The wires are flexible and you can still open the device as shown in the second picture.
Center the spudger on the top of the device, this is furthest from the wiring, in wiggling the spudger under the plate, the plate should move up and out of the shell, you can finish lifting the plate away with your fingers.

Modifier

Étape 4

Be gentle when using the opening tool, wiggle the opening tool on each side of the socket to be sure the plastic does not snap.
Be careful not to damage the wires, pull from the plastic base to unplug.
Unplug the power cable connector shown using the plastic opening tool. Wiggle the tool under the lip of the plug, the smaller area and odd angle means lifting up with the plastic tool in the setup shown.
Unplug the power connector shown using the plastic opening tool lift from the front of the plug shown and move the opening tool to either side to get it all the way out of the socket.

Modifier

Étape 5 Battery

SONY SRS-X2 Battery Replacement, Battery: étape 5, image 1 de 2

SONY SRS-X2 Battery Replacement, Battery: étape 5, image 2 de 2

Remove the four, 11 mm, Phillips#1 screws on the battery cover plate.

Modifier

Étape 6

Remove the battery cover plate carefully then proceed to remove the battery.

Modifier

How many mAh has it?

Daniel - 25 juin 2017 Réponse

Thanks for this. 3.5 volt, 1,950 mah

Dave - 31 juil. 2017 Réponse

grazie. faccio notare che nel mio sony SRS-X2 posizione e dimensioni nelle viti non corrisponde. consiglio farsi uno schema per non perdere tempo nel montaggio

Paolo Holidays - 15 avr. 2018 Réponse

Step 4 only remove the power cable of the battery (the wide multicable plug) , not the small one. The tool is not needed if you carefully and gently wiggle the plug off.

Coclsch - 4 août 2019 Réponse

What type of cell is that? 16650 or 18650?

Task514 - 20 oct. 2023 Réponse