Cette version peut contenir des modifications incorrectes. Passez au dernier aperçu vérifié.
Ce dont vous avez besoin
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Use the metal spudger to pry the face screen open. Pull away from the device to remove.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Remove seven, 27 mm long Phillips #1 screws.
-
Remove three, 11mm long Phillips #1 screws.
-
Remove four, 10 mm long Phillips#1 screws.
-
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Use the spudger to remove the speaker host plate. Insert the metal tip in the seam between the host plate and the shell.
-
Center the spudger on the top of the device, this is furthest from the wiring, in wiggling the spudger under the plate, the plate should move up and out of the shell, you can finish lifting the plate away with your fingers.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Unplug the power cable connector shown using the plastic opening tool. Wiggle the tool under the lip of the plug, the smaller area and odd angle means lifting up with the plastic tool in the setup shown.
-
Unplug the power connector shown using the plastic opening tool lift from the front of the plug shown and move the opening tool to either side to get it all the way out of the socket.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Remove the four, 11 mm, Phillips#1 screws on the battery cover plate.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Remove the battery cover plate carefully then proceed to remove the battery.
-
Annulation : je n'ai pas terminé ce tutoriel.
11 autres ont terminé cette réparation.
5 commentaires
The top two red in the middle and the bottom two orange in the middle are reversed. Other than that the instructions are good.
THANKS! You are the best!
Can anyone recommend an online store to buy a battery with the attached cable?
2400mAh Battery For Sony Bluetooth Wireless Speaker SRS-X2,9-885-197-08,SF-02