Introduction

Use this guide to remove the front casing and to access the keypad.

Apply downward pressure to the top of the battery panel while pulling down to slide it off the phone.
  • Apply downward pressure to the top of the battery panel while pulling down to slide it off the phone.

Ajouter un commentaire

Locate the grooves on the sides of the battery near the bottom of the phone. Use your fingers to pull the battery up and out of the phone.
  • Locate the grooves on the sides of the battery near the bottom of the phone. Use your fingers to pull the battery up and out of the phone.

Ajouter un commentaire

  • Use the spudger to pry the two plastic caps out of the top corners of the phone casing.

  • To get a better grip, you may use the tweezers to finish pulling the plastic caps from the phone.

Ajouter un commentaire

  • Remove the six 4.0 mm screws using the Phillips 00 screwdriver.

Ajouter un commentaire

  • Insert the plastic opening tool in the gap between the back panel and rest of the body.

  • Slide the tool along the edges until the two pieces come apart.

  • The circuit board is attached to the front casing. Both casings should separate without having to sever electrical connections.

Ajouter un commentaire

  • Pry apart the plastic tabs along the edges of the phone.

  • Separate the front panel from the main body of the phone using your fingers.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Une autre personne a terminé cette réparation.

Ryan Rumsey

Membre depuis le 30/01/2013

8 Réputation

6 tutoriels rédigés

Équipe

Cal Poly, Team 20-1, Maness Winter 2013 Membre de l'équipe Cal Poly, Team 20-1, Maness Winter 2013

CPSU-MANESS-W13S20G1

4 membres

6 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 0

Total : 380