Introduction
This guide instructs on how to replace a malfunctioning charging port circuit board.
Ce dont vous avez besoin
-
-
Before starting, ensure device is completely turned off.
-
On the back of phone, locate the slot on the top left corner.
-
Insert plastic opening tool or fingernail and pull up on the back plate.
-
With the corner released, slide your finger around the device between the back plate and the phone to release connectors.
Demander à FixBot
-
-
-
Insert fingernail into the slot on bottom of battery and gently pull up.
-
Remove the battery.
-
-
-
Remove the 14 3.45 mm Phillips #000 screws from the assembly.
-
Gently, insert plastic opening tool into seam above the volume buttons of your phone.
-
-
-
-
Slowly slide plastic opening tool around the device to release all the connectors internal to the device.
-
The device should easily come apart after the plastic opening tool is slid around the entire device.
-
-
-
Lift up on the clamp with your finger to disconnect the connector.
-
Lift up on the clamp with your finger to disconnect the connection to the mother board.
-
Grasp cable head and lift up to disconnect the cable head.
-
To reassemble your device, follow these instructions in reverse order.
Annulation : je n'ai pas terminé ce tutoriel.
10 autres ont terminé cette réparation.
Équipe
USF Tampa, Team 17-2, Blackwell Winter 2016 Membre de l'équipe USF Tampa, Team 17-2, Blackwell Winter 2016
USFT-BLACKWELL-W16S17G2
4 membres
16 tutoriels rédigés
