Aller au contenu principal
  1. Insert an opening pick between the rear case and the plastic rim. You may need to add multiple picks to detach the clips.
    • Insert an opening pick between the rear case and the plastic rim.

    • You may need to add multiple picks to detach the clips.

    • Slide the pick along the edge of the rear case until you release the plastic clips attaching the rear case to the display.

    • Continue to slide the pick around the edge of the rear case until all clips are released.

  2. Lift the case up to remove it. Lift the case up to remove it.
    • Lift the case up to remove it.

  3. Lift the plastic frame to remove.
    • Lift the plastic frame to remove.

    • Avoid the three delicate ribbon cables.

  4. Use the flat end of a plastic spudger to pry up the press-fit connector from the motherboard. Remove the camera by gently pulling upward with a pair of tweezers. Remove the camera by gently pulling upward with a pair of tweezers.
    • Use the flat end of a plastic spudger to pry up the press-fit connector from the motherboard.

    • Remove the camera by gently pulling upward with a pair of tweezers.

Conclusion

To reassemble your device, follow these instructions in reverse order.

2 autre(s) ont terminé cette réparation.

Corey Brown

Membre depuis le 24/06/2016

5 393 Réputation

11 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 2

30 derniers jours : 13

Total : 560