Cette version peut contenir des modifications incorrectes. Passez au dernier aperçu vérifié.
Ce dont vous avez besoin
-
Cette étape n’est pas traduite. Aidez à la traduire
-
To remove each strap, locate the metal latches on both sides of the back of the Gear.
-
Press down on the metal latch while pulling the strap away from the Gear until it is completely off.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Remove the four 4.0 mm screws on the back of the Gear using a T5 Torx Screwdriver.
-
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Firmly holding the Gear, insert the flat side of the spudger at an angle to pry the back casing off of the device. Move the spudger along the sides of the Gear to completely detach the back and front components.
-
Pry the device open from the other side also if it does not fully disassemble from one side.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Locate the rectangular metal connector that attaches the camera to the Gear.
-
Use tweezers to gently lift and detach the metal plate of the connector.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Use tweezers to carefully lift the camera from its slot out of the case.
-
Annulation : je n'ai pas terminé ce tutoriel.
2 autres ont terminé cette réparation.