Introduction

Use this repair guide to replace the Motherboard.

Slide the battery cover downwards with pressure focused on the center of the cover.
  • Slide the battery cover downwards with pressure focused on the center of the cover.

  • Lift the cover off of the phone.

Ajouter un commentaire

Grasp the bottom left and right corners of the battery and lift it from its housing.
  • Grasp the bottom left and right corners of the battery and lift it from its housing.

Ajouter un commentaire

  • Remove the four black 7.30 mm screws surrounding the battery housing using a Phillips #00 Screwdriver.

Ajouter un commentaire

  • The rear case is firmly attached to the phone with clips. Do not be afraid to use a little extra force.

  • Insert the Plastic Opening Tool in between the front and rear cases.

  • Pry with the Plastic Opening Tool around all edges of the phone until you free all the clips.

Ajouter un commentaire

  • Lift the rear case off of the phone.

Ajouter un commentaire

  • Remove the two black 7.30 mm screws on the top right and left corners of the Motherboard using a Phillips #00 Screwdriver.

  • Remove the silver 4.50 mm screw located below the speaker using a Phillips #00 Screwdriver.

Ajouter un commentaire

  • Use the spudger to detach the speaker ribbon cable.

Ajouter un commentaire

  • Lift the speaker out of its compartment.

Ajouter un commentaire

  • Remove the power and volume buttons on the right side of the Motherboard.

Ajouter un commentaire

  • Use a spudger to detach the camera ribbon cable.

  • Lift the camera off of the Motherboard.

Ajouter un commentaire

  • Use a spudger to disconnect the white antenna wire on the bottom right corner of the Motherboard.

Ajouter un commentaire

  • Use a Plastic Opening Tool to lift the flaps of the ZIF connectors to release the ribbon cables near the bottom of the Motherboard.

  • Use a spudger to carefully pull the ribbon cables away from the ZIF connectors.

Ajouter un commentaire

  • There is a ribbon cable under the Motherboard connecting it to the LCD. Do not pull off the Motherboard just yet.

  • Insert the Plastic Opening Tool under the upper left corner of the Motherboard to help reveal the ribbon cable.

  • Use a spudger to disconnect the Motherboard ribbon cable.

Ajouter un commentaire

  • Lift the Motherboard off of the phone.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Jaime Serrano

Membre depuis le 11/04/2011

59 Réputation

2 tutoriels rédigés

Équipe

Cal Poly, Team 24-57, Amido Spring 2011 Membre de l'équipe Cal Poly, Team 24-57, Amido Spring 2011

CPSU-AMIDO-S11S24G57

4 membres

7 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 1

Total : 2,032