Introduction

This guide shows how to replace the LCD screen on the Samsung L100.

  1. Remove the six external screws from the camera using a Phillips #0 screwdriver.
    • Remove the six external screws from the camera using a Phillips #0 screwdriver.

    • After the screws has been removed, the bottom of the back half of the external case should be loosened from the camera.

    • Be careful, make sure you don't lose the screws.

    Ajouter un commentaire

  2. Open the battery cover that's located on the bottom right side of the camera and carefully remove the battery.
    • Open the battery cover that's located on the bottom right side of the camera and carefully remove the battery.

    Ajouter un commentaire

    • Slide your fingernail or a plastic spudger in the groove from the bottom to the top right side of the camera.

    Ajouter un commentaire

    • Carefully squeeze the top right corner of the camera and pry off the external cover.

    • If you hear a "cracking" sound. This is normal.

    • Continue to pull the external cover and it will come off cleanly.

    • Be cautious of the flash capacitor. It carries an electrical charge, that may give you an unpleasant shock.

    Ajouter un commentaire

    • Carefully pull off the back cover, parts behind the back of the case might fall out.

    Ajouter un commentaire

    • Remove the screws holding the circuit board.

    • Carefully remove the circuit board.

    Ajouter un commentaire

    • Carefully lift circuit board from camera.

    • Circuit board still attached to camera by ribbon.

    Ajouter un commentaire

    • Remove the front cover. It should come off easily.

    • Buttons might fall out when you remove the front cover.

    Ajouter un commentaire

    • Remove the green tape that holds the LCD screen.

    • Carefully lift the LCD Screen.

    Ajouter un commentaire

    • Flip the camera over to the other side.

    • Lift the black strip and the ribbon should easily come out.

    • The LCD Screen should be completely separated from the camera now.

    Ajouter un commentaire

    • Insert the new LCD Screen by pushing the ribbon into the slot.

    • Flip the black strip back down to lock the ribbon in.

    • Your new LCD Screen should be connected to the camera now.

    Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Une autre personne a terminé cette réparation.

Hasit

Membre depuis le 15/04/2010

183 Réputation

2 tutoriels rédigés

Équipe

Cal Poly, Team 6-17, Maness Spring 2010 Membre de l'équipe Cal Poly, Team 6-17, Maness Spring 2010

CPSU-MANESS-S10S6G17

4 membres

5 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 1

30 derniers jours : 2

Total : 5,705