Réparez vos affaires Communauté Boutique

Samsung NX30 Screen Replacement

Introduction

The replacement of your screen takes a little work. With the right equipment though it is not too difficult to do. Just be ready to unscrew a lot of screws.

Ce dont vous avez besoin

  1. Samsung NX30 Screen Replacement, Battery: étape 1, image 1 de 1

    • Flip the camera over so that the bottom of the camera is up.

    • Push the battery switch towards the back of the camera.

    Modifier

  2. Samsung NX30 Screen Replacement: étape 2, image 1 de 2 Samsung NX30 Screen Replacement: étape 2, image 2 de 2

    • Locate the blue switch above the battery pack.

    • Slide the blue switch into the camera in the direction of the arrow on the switch. When the switch has been pushed in the battery will spring up.

    Modifier

  3. Samsung NX30 Screen Replacement: étape 3, image 1 de 1

    • Pull the battery out.

    Modifier

  5. Samsung NX30 Screen Replacement, Screen: étape 4, image 1 de 3 Samsung NX30 Screen Replacement, Screen: étape 4, image 2 de 3 Samsung NX30 Screen Replacement, Screen: étape 4, image 3 de 3

    • Unscrew the nine 4mm Phillips head screws surrounding the body of the camera. They are located on the bottom of the camera and both sides of the camera.

    Modifier

  6. Samsung NX30 Screen Replacement: étape 5, image 1 de 3 Samsung NX30 Screen Replacement: étape 5, image 2 de 3 Samsung NX30 Screen Replacement: étape 5, image 3 de 3

    • Pull the viewer out from the camera and then up.

    • Unscrew the two black 4mm Phillips head screws under it.

    Modifier

  7. Samsung NX30 Screen Replacement: étape 6, image 1 de 2 Samsung NX30 Screen Replacement: étape 6, image 2 de 2

    • Once the screws are all removed, place the camera face down, with the screen facing up.

    • Pry open the body using the plastic opening tool.

    • Gently open the body.

    Modifier

  8. Samsung NX30 Screen Replacement: étape 7, image 1 de 2 Samsung NX30 Screen Replacement: étape 7, image 2 de 2

    • Then use the plastic opening tool to dislodge the Ribbon Cable, located near the top of the camera, from the Circuit Board.

    • The Ribbon Cable will be disconnected from the Circuit Board when you are done.

    Modifier
Conclusion

To reassemble your device, follow these instructions in reverse order.

Une autre personne a terminé cette réparation.

Auteur

avec 2 autres contributeurs

Julia Kilcup

Membre depuis le 02/03/16

399 Réputation

3 tutoriels rédigés

Badges: 12

+ 9 badges supplémentaires

Équipe

UW Tacoma, Team 1-4, Rose Winter 2016 Membre de l'équipe UW Tacoma, Team 1-4, Rose Winter 2016

UWT-ROSE-W16S1G4

4 membres

10 tutoriels rédigés

0 commentaires

Ajouter un commentaire

Nombre de vues :

Dernières 24 heures : 0

7 derniers jours : 3

30 derniers jours : 14

Total : 1,816